VC4000PC only

• New feature, Remote control support
• New feature, measure slope tool
• Change, Brake runs max time increased from 25 seconds to 5 minutes
• Bug fix, Setup brake MPH changed to 253 if CLEAR used to exit
• Bug fix, Setup rollout distance changed to 253 if CLEAR used to exit

• Brake Meter, PC and DAQ versions
• New feature, Remote control support
• New feature, Measure Slope
• Change, Brake runs max time increased from 25 seconds to 5 minutes
• Bug fix, Setup brake MPH changed to 253 if CLEAR used to exit
• Bug fix, Setup rollout distance changed to 253 if CLEAR used to exit

• Bug fix, Remote Control input fields fixed
• Bug fix, Graphing GPS speed Min/Max fixed
• Bug fix, Named Setups, do-not clear auto pitch
• Bug fix, OBDII spikes

• Brake Meter, Production change only

• Bug fix, Run numbers over 255 brings up wrong run and won't import them
• DAQ (non-GPS) port 1 defaults to OFF instead of Printer (so GPS will work)

• PC and DAQ only
• Bug fix, GPS speed shows "ON" sometimes when it is OFF, Profile 5 displayed correct
• Bug fix, Graph speed show min/max
• Bug fix, Display run scrolling jumps back to select screen if scrolled fast
• Bug fix, Brake run external analog sensor start same as ext. activation start logic
• Bug fix, Diagnostic tests

• New feature, VC4000DAQ added OBDII extended PIDs (Barometric pressure, Ambient Temperature, and Hybrid Battery Pack %).
• New feature, VC4000DAQ built in CAN interface is autodetected.
• Update, External 5Hz GPS autodetect works with newer versions of GPS units.
• Change, when external GPS detected, turn on GPS speed.
• Bug fix, Battery discharge works on all models.
• Bug fix, run memory full locked up unit.
• Bug fix, run memory filebox display showed 75% when full.

• Bug fix, sensor numbers

• Bug fix, RS232 port 1 supports Data Transfer