Products>Options, Accessories and Sensors>Wireless
connection
Wireless connection to computer or thermal printer
A pair of radio modems can be used in lieu of a serial cable to
connect the VC3000 to a computer or
thermal printer. Plug in one radio modem to
the VC3000 using the provided cable and plug one into
your computers
or your thermal printers
RS232 port using the supplied cable and the supplied wall adapter.
Features
- Plug-and-communicate (default mode - no
configuration required).
- True peer-to-peer network
(no need to
configure a "Master" radio).
- Transparent mode supports existing
software applications
and legacy systems.
- Addressing capabilities provide for
point-to-point and point-to-multipoint networks.
- Uses Standard AT commands and/or fast
binary commands for changing parameters.
- Retry and
acknowledgements of packets
provides guaranteed delivery of critical packets in
difficult environments.
- Networking features allow up to 7
independent pairs (networks) to operate in close proximity.
- Multiple low power modes including
shutdown pin, cyclic sleep and serial port sleep for current
consumption
as low as 1 mA.
- Host interface baud rates from 1200 to
57600 bps.Signal strength register for link
quality
monitoring and debugging.
- Parity support (None, Even, Odd, Mark,
Space).
- Source & destination
addressing.
- Modbus support.
- DCD support.9-bit support.
- Field upgradeable firmware.
- Up to 7 mile range with dipole antenna,
up to 20 mile range with high gain antenna.
Comes with everything you need to
connect and test your radio modem using one or two PCs
(two
radio modems are required to make a wireless link).
- (1) Quick start guide
- (1) CD with documentation and software
- (1) 1/2 wave dipole antenna
(1) Serial loopback adapter
- (1) Null modem adapter (male-to-male)
(1) Male RS-485/422 adapter
- (1) Female RS-485/422 adapter (1) DB-9 male to DB-9 female serial cable
(1) AC power adapter
- (1) 9 volt battery adapter
